Tiny 6×6 120 Pinhole

This is the long awaited 6×6 120 version of my tiny pinhole camera. pinhole front 1 This is the long awaited 6×6 120 version of my tiny pinhole camera. The assembly instructions are exactly the same as the tiny pinhole camera except for the added film number viewer at the back.

pinhole back 1 This film viewer is just a simple blade with a knob that slides up and down in the groove at the back of the camera, simply glue the knob onto the blade and you’re good to go.

pinhole front 2

120 CAD

I took some test shots on a roll of Fomapan 400, which i developed in ID68, then promptly scratched with my squeegee drying tool… the emulsion on Fomapan is incredibly soft I discovered!

Pinhole 004

Pinhole 007

But this should give a good idea of what you’re in for, there is a bit of vignetting around the corners which I think is customary for the pinhole experience :-)

Pinhole 001

Pinhole 010

I metered for an f-stop of 500 with what I thought was a small, yet still practical pinhole size, so this should be a good base point for you to start form

Pinhole 012

Pinhole 008

As always here are the  STL files

Leave a Reply

Your email address will not be published. Required fields are marked *